meta data for this page
  •  

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
network:switches:cisco:cli:vlan [2024/07/18 13:31] – niziaknetwork:switches:cisco:cli:vlan [2024/08/19 12:42] (current) – niziak
Line 1: Line 1:
 ====== vlan ====== ====== vlan ======
- 
  
 ===== VLAN ===== ===== VLAN =====
Line 34: Line 33:
 no switchport access vlan no switchport access vlan
 end end
 +</code>
 +
 +==== put one port in VLAN ====
 +
 +<code>
 +conf term
 +interface Gi1/48
 +switchport access vlan 28
 +end
 +wr
 </code> </code>
  
Line 62: Line 71:
  
 <code> <code>
 +sh int vlan 28
 +
 Vlan28 is up, line protocol is down Vlan28 is up, line protocol is down
 </code> </code>
Line 96: Line 107:
 C3560G-2(config-if-range)# C3560G-2(config-if-range)#
 </code> </code>
 +
 +??? So 48 was already in trunk mode, so it looks that switch needs 2 trunk ports UP to put vlan28 up ?